Will soften cured CA. If parts are bonded incorrectly or your fingers are stuck together, a few drops of Un-Cure will dissolve the CA in about a minute. Apply on bonded skin and roll apart fingers. Once stuck, use acetone to clean off softened CA, then wash off with soap and water. Since cured CA is essentially acrylic plastic, anything that will dissolve CA will also soften most plastics. Care must be used, therefore, when using Un-Cure on plastics. Separating plastics parts with a razor saw is usually the best option.

• Softens cured CA
• Use to release parts incorrectly bonded, or glued fingers
• Not recommended for use on plastics

By starting with only the best raw materials and manufacturing processes,BSI produces the highest performing adhesives,with top-notch technical support.

BSI adhesives have earned an international reputation of being as good as,if not better than,industrial grade,at a fraction of the cost.

Glue and accelerator undergoes changes to make it better; most important is that it’s safe to use on any surface,with cure times modified to provide the strongest bond.The company stands behind its products,with a three- year guarantee on standard CA and a two-year guarantee of the foam-safe and toughened variety,as long as it is kept at room temperature or lower.